The 1000LB Motorcyle Carrier Electric Hydraulic Lift comes complete with hydraulic cylinder, hydraulic motor, and hose. All that is needed is to connect the motor to your battery. A 12v 1500psi motor runs the cylinder with a 6qt reservoir. The hydraulic motor can be mounted vertically to your motorcycle carrier so you can use your lift on multiple vehicles or you can mount the motor in your camper’s storage compartment or truck. Either way with a push of a button you will be able to quickly raise and lower you motorcycle with ease.
Designed by our engineering team with AutoCAD and manufactured in the USA in our plasma CNC facility. The 1000lb RV motorcycle carrier offers a fully electric hydraulic unit complete with cylinder and motor. No details have been over looked. The motorcycle carrier uses the industries only “Sway Lock TM” technology to ensure the motorcycle does not sway during travel. The “Sway Lock TM” makes strapping the lift to the vehicle unnecessary. The “Sway Lock TM” pin is ¾” and also works as a safety pin taking pressure off of the jack. Everything on the carrier is CNC cut to a ten thousandths of an inch. Nothing is hand cut. This allows us to custom create each piece which gives it the strength and stability it needs.
The motorcycle carrier has been engineered to lower to within 1” from the ground allowing us to build the loading ramp right on the storage platform. This means there are No Extra Parts needing to be stored or carried. You also do not have to deal with trying to drive an 800 lb motorcycle up a steep incline. The platform is 8” across and 82” long, which makes it large enough for the widest tires and longest bikes. Custom platforms are also available. The hauler also includes brackets for storing the jack handle. The RV motorcycle carrier has a standard 2” hitch receiver to pull a small trailer or flat tow a car up to 5,000lbs with the addition of the three-point hitch. Break lights and turn signal lights are included but not installed.
The carrier has a carrying capacity of 1,000 lbs. The hauler comes powder coated black and ready to go. The hauler is built using 2” solid steel tongue and fully welded gussets to hold the tong to the upright for added strength and support. The motorcycle carrier has over 18” of travel and the motorcycle platform will be raised to a full 4” above the hitch for plenty of ground clearance. The main upright tube has two extra holes for tie down stability. Four tie downs loops are integrated into the design for both added strength and stability. This is much stronger and safer than simply welding tie down brackets on.
