 |
 |
 |
|
Brand New Sealing Closed Cell
Spray Foam Insulation
Kit 15 BF
Portable, disposable and self-contained with color-coded, pre-connected hoses. Yields 15 board feet and provides a quick consistent flow of foam that dries in under a minute. Foam expands 30X. Touch N Seal Foam Kits are designed for use in commercial sealing, insulating, patching, and filling applications. Portable and disposable, these two-component foam systems provide a quick, consistent flow of polyurethane foam that dries in less than one minute.The operating temperature for this kit is between 60°F - 80°F for both the ambient (surrounding) temperature and the surface temperature of the material you are applying it to. Failure to use the kit within the recommended operating temperature range may cause your kit to dispense improperly. If stored in a cold climate, you MUST warm the kit to the recommended temperature before using it. Make sure you carefully read the instructions before using this kit.
ORDER ONLINE NOW OR
CALL 1-866-606-3991
Features:
- Yields 15 board feet or 15 square feet using a 1" layer (1 board foot = 12" x 12" x 1"), 1.25 cubic feet - this is based on ideal lab conditions, your results may vary based on environmental factors, including the temperature of the surface you are spraying, or the ambient surrounding temperature. We cannot guarantee 100% yield on any kit; for best results, please make sure to carefully follow the application guidelines and temperature guidelines
- Portable, disposable, self-contained units
- High closed cell content of cured foam makes it suitable as a general sealant to prevent air leakage in cold storage and other insulating applications
- Foam expands 30 times, dries in less than 1 minute
- Fast set-up
- Upright assembly
- No CFCs or urea formaldehyd
- Clear, color-coded hoses
- Includes illustrated instructions
- 18 Month Shelf Life, Use All Contents Within 30 Days of Initial Dispensing
Specifications:
- Density (ASTM D-1622): 1.75 +/- 0.2 pcf
- K-Factor (ASTM C-518): 0.14 BTU/in/hr^-1/ft^-1/F^-1
- R-Value (ASTM C-518): 7.12 per inch
- Compressive Strength (ASTM D-1621): 10% parallel: 19 psi, 10% perpendicular: 13.4 psi
- Tensile Strength (ASTM D-1623): 30 psi
- Dimensional Stability (ASTM D-2126): -40°F, +.88% volume change; 158°F, 100% RH, 2 Weeks:
- +14% volume change
- Water Absorption (ASTM D-2842); 1.0 - 3.5% vol
- Closed Cell Content (ASTM D-2856): 90% minimum
- Maximum Service Temperature for Cured Foam: 240°F (116°C)
This is a complete kit with hose and applicator!
ORDER ONLINE NOW OR
CALL 1-866-606-3991
|
|
|
 |
|
 |
|
|
|
